Ford Transit 2002 Owner's Manual page 212

20. Detach the main engine wiring harness bracket
from the master cylinder.
21. Remove the brake master cylinder.
Discard the nuts
Installation
CAUTION: Make sure the brake master
1.
cylinder vacuum seal is correctly positioned
before installation.
CAUTIONS:
2.
Do not touch the adhesive surface as re-
bonding will be impaired.
To make sure that the PU adhesive
cures, it is essential that all bonding surfaces
are free of moisture.
NOTE: Discard the first 100mm of PU
adhesive as this may have a reduced working
time.
NOTE: To avoid water leaks and breakage in
the continuous bead, the continuous bead
must be over lapped by 20 mm.
NOTE: Before installing the water guide,
apply the PU adhesive in a continuous bead
of between 8 and 10mm in height to the
windshield glass flange along the bond line.
Using a hot air gun, apply warm air to the
windshield glass flange and glass bond line to
remove all moisture.
3. To install, reverse the removal procedure.
4. Bleed the brake system.
For additional information, refer to:
System Bleeding
General Information, General Procedures).
http://vnx.su
Brake
(206-00 Brake System -