Ford Transit 2002 Owner's Manual page 470

31. Install the cylinder head.
Remove the prepared locating studs.
32. CAUTION: Do not re-torque the cylinder
head bolts.
NOTE: Screw in the cylinder head bolts free
of oil.
NOTE: Install new cylinder head bolts as
necessary.
Install the cylinder head bolts.
Tighten the bolts in the sequence shown,
in three stages.
Stage 1: 20 Nm
Stage 2: 40 Nm
Stage 3: 90 degrees.
NOTE: Identification numbers are provided
33.
on the outer face of the camshaft bearing
caps.
Apply sealant to the marked areas on camshaft
bearing caps 0 and 5.
34. NOTE: Only rotate the crankshaft in the
normal direction of rotation.
Turn the crankshaft until piston no. 1 is approx.
60 degrees before top dead centre (TDC).
NOTE: The identification numbers are located
35.
on the outside of the camshaft bearing caps.
NOTE: Lay the camshaft in place so that
none of the cams is at full lift.
NOTE: Apply clean engine oil to the
camshafts and camshaft bearing caps.
Install the camshafts.
36. NOTE: Screw in the camshaft bearing cap
bolts evenly, in the sequence shown, a half
turn at a time and tighten them in two
stages.
Tighten the camshaft bearing caps in two
stages.
Stage 1: 10 Nm
http://vnx.su