Ford Transit 2002 Owner's Manual page 71

stabilizer bar with no lubricant.
Install the stabilizer bar bushings.
3. Position the stabilizer bar on the crossmember.
NOTE: Do not fully tighten the stabilizer bar
4.
clamp retaining bolts at this stage.
Install the stabilizer bar clamp on both sides.
WARNING: When installing the stabilizer
5.
bar, the measurement must be taken in a
vertical plane between the crossmember and
the stabilizer bar. Failure to follow this
instruction may result in personal injury.
Set the stabilizer bar to the installation setting.
Using cable ties, support the stabilizer bar
on both sides.
6. Install the stabilizer bar.
7. Remove the cable ties.
CAUTION: Make sure the crossmember
8.
ball bearing washers are installed correctly.
NOTE: Install new ball bearing washers.
Using a suitable
special tool, position and align the crossmember.
1. Insert the alignment pins through the
crossmember alignment holes and the
washers.
2. Slide the locking plates on top of the
washers and into the groove of the tool
and tighten the alignment pin sleeve.
3. Raise the crossmember engaging the
alignment pins into the chassis aligning
http://vnx.su
transmission jack and the