57. Install the special tool.
58. Install the special tool.
Remove the cylinder block blanking plug.
59.
NOTE: Only turn the crankshaft in the normal
direction of rotation.
Turn the crankshaft to top dead center (TDC).
Turn the crankshaft slowly until the
crankshaft stops.
CAUTIONS:
60.
Make sure that the engine does not
rotate during installation of the special tool.
Make sure engine is at the TDC position
before locking the special tool.
Make sure that the special tool engages
correctly.
Using the special tool, lock the engine in
position.
NOTE: Use only latest level timing belts.
61.
These are identified by a laser etched Ford
logo.
Check the timing belt.
http://vnx.su