Ford Transit 2002 Owner's Manual page 129

Drive the tripod home onto the front drive
halfshaft.
NOTE: Use a new snap-ring.
4.
Install the tripod snap-ring.
CAUTION: The constant velocity joint
5.
must not be packed with more than 120 g of
grease.
Pack the constant velocity joint with
6. Assemble the constant velocity joint.
1. Slide a small screwdriver under the boot
seat to allow the air to escape.
2. Slide the constant velocity joint in as far
as it will go, then pull it back out 20 mm.
7. NOTE: Renew the boot clamp.
Install a new outer boot clamp using a
wrench .
8. Install the drive halfshaft.
For additional information, refer to
drive halfshaft /
Right-hand drive halfshaft
http://vnx.su
grease .
grip
Left-hand
in this section.