Ford Transit 2002 Owner's Manual page 889

Disconnect the fuel pump fuel return line quick
4
release coupling.
REFER to: Quick Release Coupling
System - General Information, General
Procedures).
Connect the special tools between the fuel pump
5
fuel return line quick release coupling and the fuel
pump.
Install the charge air cooler.
6
Start the engine.
7
Using WDS data logger function, monitor the fuel
8
system temperature until a temperature of
between 35°C and 40°C is obtained.
Stop the engine.
9
Disconnect the WDS pressure transducer from the
10
special tool 310-110.
Connect the WDS pressure transducer to the WDS
11
pressure transducer adaptor GV2323.
Using WDS, select the digital multimeter (DMM)
12
function from the toolbox menu. Select the
pressure vacuum transducer (PVT) function and
configure the DMM to display pressure/vacuum.
Start the engine.
13
Make a note of the value displayed by WDS with
14
the engine at idle and at 2000 RPM.
Is the value displayed between -175 mB to -220 mB at
idle and -180 mB to -230 mB at 2000 RPM?
Yes
Using WDS, guided diagnostic, run the fuel system
pressure test, CHECK the fuel pump high-pressure
http://vnx.su
(310-00A Fuel