Ford Transit 2002 Owner's Manual page 307

Power Steering - Power Steering Pump to
Steering Gear Pressure Line—1.8L
Duratorq-TDCi FGT (55kW/75PS) -
Lynx/1.8L Duratorq-TDDi (55kW/75PS) -
Lynx/1.8L Duratorq-TDCi (66kW/90PS) -
Lynx/1.8L Duratorq-TDCi FGT
(66kW/90PS) - Lynx/1.8L Duratorq-TDCi
VNT (66kW/90PS) - Lynx/1.8L Duratorq-
TDCi VNT (55kW/75PS) - Lynx/1.8L
Duratorq-TDCi (81kW/110PS) - Lynx
Removal and Installation
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
1. Raise and support the vehicle.
For additional information, refer to:
(100-02 Jacking and Lifting, Description and
Operation) /
Lifting (100-02 Jacking and Lifting, Description
and Operation).
2. NOTE: Note the position of the power
steering lines to aid installation.
Detach the power steering lines from the
steering gear.
CAUTIONS:
3.
Cap the power steering lines to prevent
fluid loss or dirt ingress.
Cap the steering gear valve body to
prevent fluid loss or dirt ingress.
Disconnect the power steering lines from the
steering gear valve body.
1. Remove the retaining bolt.
2. Rotate the clamp plate.
Allow the fluid to drain into a suitable
container.
Discard the O-ring seals.
4. Lower the vehicle.
5. Remove the charge air cooler inlet pipe.
1. Loosen the retaining clips.
2. Remove the retaining nuts.
6. Remove the charge air cooler outlet pipe.
http://vnx.su
Print
Jacking