Ford Transit 2002 Owner's Manual page 120

using a soft cloth to prevent damage.
Using the special tool, detach the tie-rod end
from the wheel knuckle (left-hand side shown).
1. Release the tie-rod end.
2. Remove the tie-rod end retaining nut.
Discard the nut.
NOTE: Use a T50 Torx driver to prevent the
6.
ball joint from rotating.
Loosen the lower arm ball joint retaining nut.
CAUTIONS:
7.
Leave the lower arm ball joint retaining
nut in place to protect the ball joint stud.
Protect the ball joint seal using a soft
cloth to prevent damage.
Using a suitable
arm from the wheel knuckle.
1. Use a soft faced hammer to strike the
lower arm.
2. Remove and discard the retaining nut.
CAUTION: Secure the halfshaft to
8.
prevent damage to the CV joints. The inner
CV joint must not be bent more than 18
degrees. The outer CV joint must not be bent
more than 45 degrees.
Using a suitable
halfshaft from the wheel hub.
CAUTIONS:
9.
Secure the halfshaft to prevent damage
to the CV joints. The inner CV joint must not
be bent more than 18 degrees. The outer CV
joint must not be bent more than 45
degrees.
Make sure that the inner CV joint boot is
not damaged.
NOTE: Discard the grease filling.
Remove the halfshaft.
Remove and discard the CV joint boot
retaining clamps.
http://vnx.su
two leg puller, detach the lower
three leg puller, detach the