Ford Transit 2002 Owner's Manual page 965

WARNINGS:
Do not smoke or carry lighted tobacco or open flame of any type when working on or
near any fuel related components. Highly flammable mixtures are always present and
may ignite. Failure to follow these instructions may result in personal injury.
This procedure involves fuel handling. Be prepared for fuel spillage at all times and
always observe fuel handling precautions. Failure to follow these instructions may result
in personal injury.
CAUTION: Diesel fuel injection equipment is manufactured to very precise tolerances
and fine clearances. It is therefore essential that absolute cleanliness is observed when
working with these components.
10. CAUTION: O-ring seals must only be
removed from the fuel injection pump, using
a blunt plastic tool. Failure to follow this
instruction may result in damage to the fuel
injection pump.
Inspect the fuel injection timing solenoid to make
sure both O-ring seals are still fitted. If the fuel
injection timing solenoid O- ring seal(s) is missing
from the fuel injection timing solenoid, the
missing fuel injection timing solenoid O-ring seal
(s) must be removed from the fuel injection
pump using a suitable
11. Remove the fuel injection timing solenoid.
Cut the fuel injection timing solenoid wiring
harness as close to the fuel injection
timing solenoid as possible.
12. Lower the vehicle.
Installation
CAUTION: Do not remove the fuel
1.
injection timing solenoid protective cover
supplied with the new fuel injection timing
solenoid at this stage. Failure to follow this
instruction may result in failure of the fuel
injection solenoid or fuel injection pump.
Remove the fuel injection timing solenoid
electrical connector.
http://vnx.su
blunt plastic tool.