Ford Transit 2002 Owner's Manual page 109

Wobble or * Damaged wheel.
shimmy
affecting wheel
runout
* Front wheel
bearing.
Excessive * Suspension
vehicle components.
vibration,
rough steering
Vehicle * Incorrect tire
vibrations from pressure(s).
wheels and
* Wheel or tire
tires
imbalance.
* Uneven tire wear.
* Brake disc
imbalance.
* Water in tire(s).
* Bent wheel.
* Incorrectly seated
tire bead.
* Excessive lateral
or radial runout of
wheel or tire.
* Foreign material
between wheel
mounting face and
hub mounting
surface.
* Front wheel
bearing.
Rust streaks * Wheel nuts.
from the wheel
stud holes in
the wheel
necessary. REFER to: (204-04 Wheels and Tires)
Specifications (Specifications),
Wheel and Tire (Removal and Installation).
* INSPECT the wheel rims for damage. BALANCE the
wheel and tire assemblies. Using a suitable dial
indicator gauge and holding fixture, CHECK lateral and
radial runout of the wheel and tire assemblies.
INSTALL new wheel and tire assemblies as necessary.
REFER to: (204-04 Wheels and Tires)
Specifications (Specifications),
Wheel and Tire (Removal and Installation).
* CHECK or INSTALL new wheel bearings as necessary.
REFER to: Front Wheel Bearing
Suspension, Removal and Installation).
* CHECK or INSTALL new suspension components as
necessary.
* ADJUST the tire pressure(s).
* BALANCE the wheel and tire assemblies.
* INSTALL a new tire(s) as necessary. REFER to:
and Tire (204-04 Wheels and Tires, Removal and
Installation).
* CHECK the brake disc for foreign material.
* REMOVE the water.
* INSTALL a new wheel and tire assembly. REFER to:
Wheel and Tire (204-04 Wheels and Tires, Removal
and Installation).
* SPIN the wheel on the vehicle. EXAMINE the area
where the tire and the wheel meet. If that section of
the tire appears to waver while being rotated, the tire
bead may not be correctly seated on the wheel.
REMOVE the tire and CLEAN the bead seat areas on
both wheel and tire.
* BALANCE the wheel and tire assemblies. Using a
suitable dial indicator gauge and holding fixture,
CHECK the lateral and radial runout of the wheel and
tire assemblies. INSTALL new wheel and tire
assemblies as necessary. REFER to: (204-04 Wheels
and Tires)
Specifications (Specifications),
Wheel and Tire (Removal and Installation).
* CLEAN mounting surfaces.
* CHECK or INSTALL new wheel bearings as necessary.
REFER to: Front Wheel Bearing
Suspension, Removal and Installation).
* REMOVE the wheel and tire assembly. Inspect the
wheel nuts and wheel and tire assembly for damage.
INSTALL new wheel nuts and wheel and tire
assemblies as necessary. REFER to: (204-04 Wheels
and Tires)
Specifications (Specifications),
http://vnx.su
(204-01 Front
Wheel
(204-01 Front