Front Drive Halfshafts-Outer Constant Velocity (Cv) Joint Boot - Ford Transit 2002 Owner's Manual

Front Drive Halfshafts - Outer Constant
Velocity (CV) Joint Boot
Removal and Installation
Special Tool(s)
Clamping Tool, Boot Retaining Clamp
204-169 (14-044)
General Equipment
Expanding pliers, snap-ring
Materials
Name
Constant velocity joint
high-temperature grease
Specification
ESP-M1C207-A
1. Remove the inner CV joint boot.
For additional information, refer to:
Constant Velocity (CV) Joint Boot
Drive Halfshafts, Removal and Installation).
2.
covers.
Remove the outer CV joint boot.
Installation
1. NOTE: Install a new rubber boot.
Install the outer CV joint boot.
1. Insert a small screwdriver under the boot
2. Position the rubber boot.
NOTE: Install a new clamping strap.
2.
Insert the inner clamping strap into the ring
groove of the rubber boot and tighten with the
special tool.
http://vnx.su
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
CAUTION: Use a vice with protective jaw
Cut and discard the boot clamps.
Remove and discard the rubber boot.
Remove the grease packing.
Pack the CV joint with grease.
For additional information, refer to:
Specifications (205-04 Front Drive
Halfshafts, Specifications).
Press the rubber boot into the groove of
the CV joint.
seat to allow the air to escape.
Remove the screwdriver.
Print
Inner
(205-04 Front