Ford Transit 2002 Owner's Manual page 756

10. Install the power steering line retaining bracket
(crossmember shown removed for clarity).
11. Install the steering gear heat shield (two bolts).
12. CAUTION: Make sure that the
crossmember ball bearing washers are
installed correctly.
Using a suitable transmission jack and the
special tool, position and align the crossmember.
1. Insert the alignment pins through the
crossmember alignment holes and the
washers.
2. Slide the locking plates on top of the
washers and into the groove of the special
tool and tighten the alignment pin sleeve.
3. Raise the crossmember engaging the
alignment pins into the chassis alignment
holes.
CAUTION: Make sure that the
13.
crossmember does not move while
tightening the crossmember retaining bolts.
Install the crossmember retaining bolts
(transmission jack shown removed for clarity).
14. Remove the retaining strap and the transmission
http://vnx.su