Ford Transit 2002 Owner's Manual page 927

Make sure that the tool used to loosen the high-pressure fuel supply line union is
used at the top of the union as this is where there is most material. Failure to follow this
instruction may result in damage to the union.
Item 11 : Number four fuel injector, high-pressure fuel supply line
NOTE: Using the engine vacuum cleaner, vacuum foreign material from the high-pressure
fuel supply line, the fuel injector and the fuel injection supply manifold.
Item 15 : Number four fuel injector
NOTE: Clean the area around the fuel injector. For additional information, refer to Fuel
Injection Component Cleaning in this Section.
Item 16 : Number four fuel injector sealing washer
NOTE: Discard the fuel injector sealing washer.
Installation Details
Item 16 : Number four fuel injector sealing washer
NOTE: Install a new fuel injector sealing washer.
Item 15 : Number four fuel injector
NOTE: Remove and discard the fuel injector nozzle blanking plug.
Item 13 : Number four fuel injector clamp retaining bolt
1. Install a blanking caps to the open threaded
ports of the fuel injector and the fuel injection
supply manifold.
1. Install the fuel injector sealing washer.
1. Record the identification code from the new fuel
injector to upload into WDS during configuration
(the graphic shows an example of the
identification code only).
http://vnx.su