7. Detach the brake booster actuating rod from the
brake pedal.
1. Depress the brake pedal.
2. Depress the clip.
3. Remove the brake booster actuating rod
pin.
8. Remove the brake booster retaining nuts.
9. Remove the brake booster.
Discard the gasket.
Installation
1.
CAUTIONS:
Make sure that the brake booster
actuating rod is correctly positioned through
the bulkhead rubber boot.
Make sure the brake booster gasket is
correctly positioned on the brake booster
before installation.
NOTE: Install a new gasket.
To install, reverse the removal procedure.
http://vnx.su