Ford Transit 2002 Owner's Manual page 541

12. Install the special tool.
Remove the cylinder block blanking plug
and install the special tool.
NOTE: Only turn the crankshaft in the normal
13.
direction of rotation.
Turn the crankshaft to TDC.
Turn the crankshaft slowly until the
crankshaft stops.
CAUTIONS:
14.
Make sure that the crankshaft does not
rotate during installation of the special tool.
Make sure crankshaft is at the TDC
position before locking the special tool.
Make sure that the special tool engages
correctly.
Using the special tool, lock the crankshaft.
15. Lower the vehicle.
16. Install the special tools.
17. Remove the engine front mount.
18. Remove the engine front mount stud.
http://vnx.su