Power Steering - Steering Gear
Removal and Installation
Special Tool(s)
Separator, Ball Joint
211-020 (13-006)
Alignment Pins, Subframe
205-316 (15-097A)
General Equipment
Transmission jack
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
1.
NOTE: Make sure the road wheels are in the
straight ahead position.
Centralize the steering wheel and lock it in
position.
2. Detach the steering column shaft from the
steering gear pinion extension.
Discard the retaining bolt.
3. Raise and support the vehicle. For additional
information, refer to Section
Lifting.
4. Disconnect the steering gear to power steering
fluid hose quick release coupling from the power
steering fluid cooler.
1. Press the power steering fluid cooler hose
quick release coupling locking tangs.
2. Disconnect the power steering fluid cooler
hose quick release coupling.
Allow the fluid to drain into a suitable
container.
CAUTION: Leave the tie-rod end
5.
retaining nut in place to protect the ball joint
http://vnx.su
Print
100- 02 Jacking and