Ford Transit 2002 Owner's Manual page 153

less than the specified minimum, a new
brake disc must be installed and the brake
disc runout re-checked.
Check the brake disc thickness variation.
Using a suitable micrometer, measure the
brake disc thickness at eight positions, 45
degrees apart and approximately 15 mm
from the outer edge of the brake disc.
7. If all the brake disc runout measurements and
the thickness variation are within the
specifications, check the wheel balance.
8. If just the brake disc runout measurement with
the wheel and tire fitted exceeds the
specification, the wheel and tire must be rotated
through 90 degrees in relation to the brake disc
and the brake disc runout re-checked.
If the brake disc runout measurement still
exceeds the specification, repeat the wheel
and tire rotation and checking process until
the measurement is within specification.
9. If the brake disc runout measurement without
the wheel and tire fitted is outside the
specification, check the wheel hub face runout.
NOTE: Using paint or typing correction fluid,
10.
mark the position of the brake disc in relation
to the wheel hub.
Remove the brake disc. For additional
information, refer to Section
Brake / 206-04 Rear Disc
NOTE: Make sure that the wheel hub face is
11.
clean and free of rust and foreign material.
NOTE: Re-position the dial indicator gauge
so that it contacts the wheel hub
approximately 10 mm from the outer edge of
the wheel hub.
Check the wheel hub face runout.
Slowly rotate the wheel hub and note the
readings.
12. If the wheel hub runout exceeds 0.03 mm, install
a new wheel hub. For additional information,
refer to Section
02 Rear Suspension.
13. If the wheel hub face runout is within
specification, install a new brake disc. For
additional information, refer to Section
Front Disc Brake
http://vnx.su
206-03 Front Disc
Brake.
204-01 Front Suspension
/ 206-04 Rear Disc Brake.
/ 204-
206-03