Ford Transit 2002 Owner's Manual page 349

NOTE: Turn the spark plug connector slightly before disconnecting it. Pull the connector
and not the lead.
3. 3. Detach the spark plug connectors and remove the spark plugs.
4. 4. Disconnect the ignition coil (EI) electrical connector.
NOTE: Operate the starter motor with wide open throttle until the pointer on the
measuring device stops rising.
5. 5. Using a suitable compression pressure recorder carry out the measurement on
every cylinder.
6. 6. Refit the components in reverse order, observing the prescribed torques. Coat the
spark plug connector seal with silicone grease (A960-M1C-AA) before fitting. Coat
the spark plug thread with lubricant (ESE-M1244-A). Valve cover torque: Stage 1: 2
Nm; stage 2: 7 Nm. Spark plug torque: 15 Nm.
7. 7. Reset the PCM fault memory.
Measure the compression pressure (1.8L diesel engine - without common rail fuel
injection)
WARNING: Do not smoke or carry lighted tabacco or open flame of any type when
http://vnx.su