Ford Transit 2002 Owner's Manual page 604

36. Using the special tool, remove the cylinder head.
Discard the gasket.
Installation
All vehicles
1. Clean the mating faces of the cylinder head and
cylinder block with
2. Check the cylinder head for distortion. For
additional information, refer to Section
Engine System - General
CAUTION: The thickness of the new
3.
cylinder head gasket must be the same as
that of the old one (hole/tooth marked).
NOTE: "TOP/OBEN" mark.
Install a new cylinder head gasket.
NOTE: Make sure that the special tool is
4.
engaged in the camshaft groove.
Using the special tool, position the cylinder head
on the cylinder block.
Remove the special tool.
http://vnx.su
Loctite 7070.
303-00
Information.