Ford Transit 2002 Owner's Manual page 125

Close off the transmission openings to
prevent fluid loss or dirt ingress.
Remove the intermediate shaft.
Collect the fluid in a suitable container.
Remove and discard the center bearing
cap and locknuts.
Pull the intermediate shaft out of the
transmission.
Installation
1. CAUTION: Ensure that the halfshaft oil
seal is not damaged.
Install the intermediate shaft in the
transmission.
NOTE: Install a new intermediate shaft
2.
center bearing cap and new locknuts.
NOTE: Insert the intermediate shaft into the
transmission until the intermediate shaft
bearing contacts the rib of the intermediate
shaft bracket.
Install the intermediate shaft in the
transmission.
Install the center bearing cap and
locknuts.
CAUTION: Secure the halfshaft to
3.
prevent damage to the constant velocity
joints. The inner constant velocity joint must
not be bent by more than 18 degrees. The
outer constant velocity joint must not be
bent by more than 45 degrees.
Attach the right halfshaft to the tripode housing.
4. Install the gaiter clamping strap for the halfshaft
joint.
Push a small screwdriver under the gaiter
seat to allow air to escape.
Install the tripode housing and pull it
backwards 20 mm.
WARNING: Use a new lower suspension
5.
arm ball joint retaining nut. Failure to
observe this instruction can lead to injury.
http://vnx.su