Ford Transit 2002 Owner's Manual page 450

Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
Cap the transaxle to prevent oil loss or
dirt ingress.
Detach the right-hand halfshaft and the
intermediate shaft from the transaxle and secure
it to one side.
Allow the oil to drain into a suitable
container.
CAUTIONS:
29.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
Cap the transaxle to prevent oil loss and
dirt ingress.
Using the special tool, detach the left-hand
halfshaft from the transaxle and secure it to one
side.
Discard the snap ring.
Allow the oil to drain into a suitable
container.
30. Disconnect the vehicle speed sensor (VSS)
electrical connector.
31. Disconnect the crankshaft position (CKP) sensor
electrical connector.
32. Detach the gearshift cables from the transaxle.
1. Detach the gearshift cable (colored white)
and the selector cable (colored black) from
the selector levers.
2. Turn the abutment sleeves clockwise and
http://vnx.su