Ford Transit 2002 Owner's Manual page 723

direction of rotation.
NOTE: Using a suitable marker, mark the
crankshaft pulley to show TDC.
Turn the engine six revolutions.
74. Install the special tool.
NOTE: Only turn the engine in the normal
75.
direction of rotation.
Turn the engine to TDC.
Turn the engine slowly until the crankshaft
stops.
76. CAUTIONS:
Make sure that the engine does not
rotate during installation of the special tool.
Make sure the engine is TDC position
before locking the special tool.
Make sure that the special tool engages
correctly.
Using the special tool, lock the engine in
position.
77. Lower the vehicle.
CAUTION: If the pointer is not visible in
78.
the timing belt tensioner window, the timing
belt tensioning steps must be repeated.
Check that the timing belt tensioner pointer is
positioned in the window.
CAUTION: If the special tool cannot be
79.
installed, the timing belt tensioning steps
must be repeated.
Install the special tool.
If the special tool cannot be installed,
repeat procedure from previous steps.
http://vnx.su