stud.
NOTE: Use a 5 mm Allen key to prevent the
ball joint stud from rotating.
Loosen the tie-rod end retaining nut on both
sides.
CAUTION: Protect the ball joint seal
6.
using a soft cloth to prevent damage.
Using the special tool, detach the tie-rod end
from the wheel knuckle on both sides.
1. Release the tie-rod end.
2. Remove and discard the tie-rod end
retaining nut.
NOTE: Use a 5 mm Allen key to prevent the
7.
ball joint stud from rotating.
Detach the stabilizer bar connecting link from the
strut and spring assembly on both sides.
8. Remove the engine support insulator center
retaining bolt.
9. Remove the steering gear heat shield.
10. Detach the power steering lines from the
steering gear.
http://vnx.su