Ford Transit 2002 Owner's Manual page 418

02 Jacking and Lifting, Description and
Operation).
9. Remove the special tool.
10. NOTE: Only rotate the crankshaft in the
normal direction of rotation.
Using the crankshaft pulley, rotate the
crankshaft two revolutions until piston No. 1 is at
TDC.
11. Install the special tool.
Rotate the crankshaft against the special
tool.
12. Remove the crankshaft pulley.
13. Lower the vehicle.
CAUTION: It is possible that the timing
14.
belt tensioner marks do not align after
rotating the crankshaft. Do not re-tighten
the timing belt if the timing belt tensioner
marks do not align.
Install the special tool, check the valve timing.
Loosen the camshaft pulleys, correct the
camshaft alignment if necessary.
15. Remove the special tool.
16. Raise and support the vehicle.
For additional information, refer to:
02 Jacking and Lifting, Description and
Operation).
17. Remove the special tool.
http://vnx.su
Lifting (100-