Ford Transit 2002 Owner's Manual page 934

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when
working on or near any fuel related components. Highly flammable mixtures are always
present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION: Diesel fuel injection equipment is manufactured to very precise tolerances
and fine clearances. It is therefore essential that absolute cleanliness is observed when
working with these components. Always install blanking plugs to any open orifices or
lines.
6. NOTE: Fuel injection pump shown removed
for clarity.
Remove the fuel injection one-way valves.
Discard the fuel injection one-way valves.
NOTE: Fuel injection pump shown removed
7.
for clarity.
Using a clean small screwdriver
the sealing washers.
Discard the sealing washers.
Installation
1. Lubricate the fuel injection one-way valves with
Renap 220 oil (supplied in the parts kit).
2. Position the sealing washers onto the end of the
fuel injection one-way valves.
NOTE: Fuel injection pump shown removed
3.
for clarity.
Install the fuel injection one-way valves.
http://vnx.su
, carefully remove