Ford Transit 2002 Owner's Manual page 435

7. CAUTION: Make a note of the
installation position of the adjusting shims
between the transmission and lower
crankcase for use during installation. The
adjusting shims must be put back in their
original positions when the oil pump is
installed.
Remove the lower crankcase (shown with engine
removed for clarity).
Discard the gasket.
8. Remove the auxiliary drive belt tensioner.
9. Remove the oil pump (shown with engine
removed for clarity).
Discard the gasket.
Installation
NOTE: Renew the oil pump gasket.
1.
NOTE: Do not fully tighten the oil pump
retaining bolts at this stage.
Install the oil pump (shown with engine removed
for clarity).
2. Align the oil pump on both sides using a
edge straight-edge
lies 0,3 mm - 0,8 mm above the lower edge of
the cylinder block.
3. Tighten the oil pump bolts in two stages (engine
shown removed for clarity).
Stage 1: 6 Nm
http://vnx.su
knife-
so that the contact surface