Anti-Lock Control-Hydraulic Control Unit (Hcu) - Ford Transit 2002 Owner's Manual

Anti-Lock Control - Hydraulic Control Unit
(HCU)
Removal and Installation
General Equipment
Transmission jack
Securing straps
CAUTION: If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
All vehicles
1. CAUTION: The brake fluid reservoir cap
must not become contaminated.
Remove the brake fluid reservoir cap.
Disconnect the low brake fluid warning
indicator switch electrical connector.
NOTE: It will be necessary to carry out this
2.
step on both sides in order to completely
drain the brake fluid reservoir.
Drain the brake fluid reservoir.
1. Connect one end of a suitable piece of
clear plastic pipe to the bleed nipple and
place the other end into a suitable
container.
2. Loosen the bleed nipple.
3. Depress the brake pedal until all the brake
fluid is drained from the brake fluid
reservoir.
4. Tighten the bleed nipple.
3. Install the brake fluid reservoir cap.
4. Remove the air cleaner. For additional
information, refer to Section
Distribution and Filtering.
5. Remove the air cleaner outlet tube.
6. Remove the battery tray. For additional
information, refer to Section
Mounting and Cables.
7. Detach the transaxle breather assembly from the
air cleaner bracket.
http://vnx.su
Print
303-12 Intake Air
414-01 Battery,