Ford Transit 2002 Owner's Manual page 70

wooden block, support the crossmember.
11. Using a suitable securing
crossmember to the
12. Remove the crossmember retaining bolts
(transmission jack removed for clarity).
13. Lower the crossmember approximately 100 mm.
14. Remove and discard the crossmember ball
bearing washers.
15. Remove the stabilizer bar clamp on both sides.
16. Remove the stabilizer bar.
17. Remove the stabilizer bar bushing on both sides.
Installation
1. Check the lower arm ball joint heat shield for
damage. Install a new heat shield if necessary.
For additional information, refer to
Ball Joint in this section.
2. CAUTION: The stabilizer bar bushings
must be located correctly on the flats of the
http://vnx.su
strap, secure the
transmission jack.
Lower Arm