the moment.
Install the oil pump.
NOTE: Align the oil pump on both sides so
6.
that the mating face is between 0.3 mm and
0.8 mm above the lower edge of the cylinder
block.
Align the oil pump using a
7.
NOTE: Install the new crankshaft front oil
seal.
Slide the crankshaft front oil seal onto the
special tool.
NOTE: For the moment, do not fully install
8.
the crankshaft front oil seal.
NOTE: The crankshaft journals must be clean
and free of oil or grease.
Slide the crankshaft front oil seal with the special
tool onto the crankshaft.
9. Remove the special tool .
10. Install the crankshaft front oil seal and
crankshaft pulley bolt.
11. Remove the special tool and the crankshaft
pulley bolt.
12. Tighten the oil pump bolts in two stages.
Stage 1: 6 Nm
Stage 2: 45 degrees
http://vnx.su
steel
rule.