Ford Transit 2002 Owner's Manual page 444

Clean all traces of oil residue from the oil pan.
CAUTION: The lower crankcase may be
3.
damaged if sealer enters the blind holes.
Install ten M6 x 20 mm studs
blind holes (engine shown removed for clarity).
NOTE: Install the oil pan within ten minutes
4.
of applying the sealer.
Apply a 3 mm diameter bead of
pan mating face.
NOTE: The oil pan must not be removed once
5.
it comes into contact with the lower
crankcase housing.
Install the oil pan.
Remove the
6. Install the oil pan retaining bolts.
Tighten the bolts in the sequence shown in
two stages.
Stage 1: 6 Nm.
Stage 2: 10 Nm.
NOTE: Inspect the oil drain plug seal for
7.
damage. Install a new oil drain plug and seal
if necessary.
Install the oil pan drain plug.
8. Install the catalytic converter. For additional
information, refer to Section
System.
9. Fill the engine with engine oil.
For additional information, refer to
in this section.
http://vnx.su
into the indicated
sealer to the oil
ten M6 x 20 mm studs.
309-00 Exhaust
Specification