Ford Transit 2002 Owner's Manual page 484

5. Remove the engine
6. Raise and support the vehicle. For additional
information, refer to Section
Lifting.
7. Position the engine and transaxle assembly in
the engine compartment.
Carefully lower the vehicle until the engine
and transaxle assembly is supported by
the workshop
8. NOTE: Install new engine front mount
retaining nuts.
NOTE: Do not tighten the engine front mount
retaining nuts at this stage.
Install the engine front mount retaining nuts.
NOTE: Install a new rear mount center
9.
retaining nut.
NOTE: Do not tighten the engine rear mount
center retaining nut at this stage.
Install the engine rear mount center retaining
nut.
10. Raise the vehicle and remove the
table.
11. Attach the gearshift cables to the transaxle.
Attach the gearshift cables to the bracket
and turn the abutment sleeves
counterclockwise.
http://vnx.su
hoist.
100- 02 Jacking and
table.
workshop