Front Drive Halfshafts - Front Halfshaft
RH
Removal and Installation
Special Tool(s)
Installer, Halfshaft
204-161 (14-041)
Separator, Ball Joint
211-020 (13-006)
General Equipment
Three leg puller
Two leg puller
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
1. Loosen the strut and spring assembly top mount
nuts by five turns.
CAUTION: Use a socket to loosen the
2.
wheel hub retaining nut to prevent damage.
Loosen the wheel hub retaining nut.
Discard the nut.
3. Remove the wheel and tire. For additional
information, refer to Section
Tires.
CAUTION: Leave the tie-rod end
4.
retaining nut in place to protect the ball joint
stud.
NOTE: Use a 5 mm Allen key to prevent the
ball joint from rotating.
Loosen the tie-rod end retaining nut (left-hand
side shown).
5.
CAUTION: Protect the ball joint seal,
http://vnx.su
Print
204-04 Wheels and