Parking Brake And Actuation-Parking Brake Cable Adjustment - Ford Transit 2002 Owner's Manual

Parking Brake and Actuation - Parking
Brake Cable Adjustment
General Procedures
Transit/Tourneo Connect 2002.5 (06/2002-)
All vehicles
1. Remove the parking brake control boot.
2. Release the parking brake.
3. Loosen the parking brake cable adjustment nut
to the end of the thread.
Remove and discard the retaining clip.
4. NOTE: The right-hand cable can be identified
by a sleeve on the outer cable.
Make sure the parking brake cable is correctly
located.
NOTE: Prior to carrying out adjustment to a
5.
new or relocated parking brake cable, settle
the parking brake system.
Settle the parking brake system in three stages.
Stage 1: Raise the parking brake control
seven notches.
Stage 2: Tighten the adjustment nut to 6
Nm.
Stage 3: Loosen the adjustment nut to the
end of the thread.
Vehicles with rear drum brakes
6. Using a suitable rolling road, carry out a brake
test. For additional information, refer to Section
100-00 General Information.
7. Start the engine.
8. Depress and release the brake pedal firmly
fifteen times.
9. Raise the parking brake control seven notches.
10. Tighten the parking brake cable adjustment nut.
Install a new retaining clip.
http://vnx.su
Print