NOTE: Install new flywheel bolts.
21.
Using the special tool, install the flywheel.
Tighten the bolts in three stages in the
sequence shown.
Stage 1: 18 Nm.
Stage 2: 45 degrees.
Stage 3: 45 degrees.
22. Remove the special tool.
23. Using the special tool, centralize the clutch disc
on the pressure plate.
CAUTION: Tighten the clutch pressure
24.
plate retaining bolts finger tight and then by
two turns at a time in the sequence shown to
the specified torque.
Using the special tool, install the clutch disc and
pressure plate.
Remove the special tool.
25. Using the special tool, install the CKP sensor
retaining bracket.
26. Install the coolant distribution pipe.
http://vnx.su