Ford Transit 2002 Owner's Manual page 926

16 -
7. To install, reverse the removal procedure.
Removal Details
Item 6 : Fuel return line
Item 8 : High-pressure fuel supply line clamp
Item 9 : High-pressure fuel supply line to number four fuel injector union
CAUTIONS:
Use an open-ended wrench to prevent the component from turning.
Make sure that the high-pressure fuel supply line remains in contact with the fuel
injector until both unions have been detached and cleaned. Failure to follow this
instruction may result in foreign matter ingress to the fuel injection system.
Make sure that the tool used to loosen the high-pressure fuel supply line union is
used at the top of the union as this is where there is most material. Failure to follow this
instruction may result in damage to the union.
Item 10 : High-pressure fuel supply line to fuel injection supply manifold union
CAUTIONS:
Make sure that the high-pressure fuel supply line remains in contact with the fuel
injector until both unions have been detached and cleaned. Failure to follow this
instruction may result in foreign matter ingress to the fuel injection system.
See Removal Detail
See Installation Detail
Number four fuel injector sealing washer
See Removal Detail
See Installation Detail
8. Using WDS, configure the fuel injector(s) to the
PCM.
1. Install a blanking cap to the fuel injector fuel
return line spigot.
1. Make a note of the orientation of the clamp to
make sure it is positioned in exactly the same
position when installed.
http://vnx.su