6. Disconnect the parking brake cable from the
brake shoe.
7. Remove the brake shoes.
Installation
CAUTION: Make sure that the brake
1.
shoe adjuster is pre-set to give a brake shoe
diameter of 228 mm before installing the
brake drum.
NOTE: Install a new parking brake cable
retaining clip.
To install, reverse the removal procedure.
Apply
grease
strut.
Clean the backing plate and apply
dielectric compound
contact points.
2. Adjust the parking brake cable.
For additional information, refer to:
Brake Cable Adjustment
and Actuation, General Procedures).
http://vnx.su
to the brake shoe adjuster
silicon
to the brake shoe
Parking
(206-05 Parking Brake