Ford Transit 2002 Owner's Manual page 469

disc is pushed on to the transmission input
shaft.
Evenly coat the splines of the clutch disc with
high-temperature
25. Center the clutch disc on the clutch pressure
plate using the special tool.
26. Install the clutch disc and pressure plate.
1. Position the clutch pressure plate with the
centered clutch disc.
2. Working diagonally in several stages,
tighten the bolts a turn at a time.
3. Check the centering and correct as
necessary.
27. Make two guide studs as shown in the diagram.
CAUTION: The choice of cylinder head
28.
gasket depends on the cast cylinder block
number.
Check the cylinder block number.
NOTE: Install a new cylinder head gasket.
29.
Lay a new cylinder head gasket on the cylinder
block.
30. Install the prepared locating studs.
http://vnx.su
grease.