metal fragments.
Protect the face of the wheel speed
sensor ring with a suitable non-ferrous flat
block to prevent damage.
Make sure the brake drum is adequately
supported and do not allow it to rest on the
wheel studs.
Make sure the wheel speed sensor ring is
pressed on slowly and squarely until fully
seated.
Do not exceed a maximum load of 10
kn.
Using a suitable hydraulic press install a new
wheel speed sensor ring.
Vehicles with rear disc brakes
2. Install the rear wheel hub. For additional
information, refer to Section
Suspension.
Vehicles with rear drum brakes
CAUTION: Rotate the drum in the
3.
opposite direction when tightening the hub
nut to prevent damage to the bearing.
Install the brake drum.
4. Install the dust cap.
5. Install the wheel and tire assembly. For
additional information, refer to Section
Wheels and
Tires.
http://vnx.su
204-02 Rear
204-04