normal direction of rotation.
NOTE: Using paint or typing correction fluid,
mark the crankshaft pulley to show top dead
center (TDC).
Turn the crankshaft six revolutions.
14. Install the special tool.
NOTE: Only turn the crankshaft in the normal
15.
direction of rotation.
Turn the crankshaft to TDC.
Turn the crankshaft slowly until the
crankshaft stops.
16.
CAUTIONS:
Make sure that the crankshaft does not
rotate during installation of the special tool.
Make sure crankshaft is at the TDC
position before locking the special tool.
Make sure that the special tool engages
correctly.
Using the special tool, lock the crankshaft.
17. Lower the vehicle.
18.
NOTE: The auto tensioner pointer may move
slightly upwards in the window.
Check that the autotensioner pointer is
positioned in between the sides of the window.
1. If the pointer is in the window, go to the
following step.
2. If the pointer is not in the window, repeat
procedure from the previous steps.
19. Install the special tool.
If the special tool cannot be installed,
repeat the procedure from the previous
steps.
http://vnx.su