Ford Transit 2002 Owner's Manual page 978

10. Install the fuel injection one-way valves.
11. Cut the wires that connect into the fuel injection
pump. Trim the end of the insulation to expose
the wiring.
12. Cut the wires that connect into the new metering
valve. Trim the end of the insulation to expose
the wiring.
13. NOTE: The fuel metering valve wiring can be
connected to the fuel injection pump wiring
either way round and it will not affect the
function of the new fuel metering valve.
Slide the protection sleeve and connector
insulation sleeves (supplied in the parts kit) over
the wiring. Join the fuel injection pump wiring to
the fuel metering valve wiring by crimping the
electrical connectors (supplied in the parts kit).
CAUTION: The electrical connectors
14.
must be correctly sealed to prevent water
ingress which could affect the operation of
the fuel metering valve.
Using a heat gun, heat shrink the connector
insulation sleeves over the electrical connectors.
15. Install the protection sleeve over the fuel
injection pump wiring harness.
http://vnx.su