Ford Transit 2002 Owner's Manual page 710

6. Coat the cylinder bores with clean
NOTE: Install the pistons with the arrows
7.
pointing to the front of the engine.
NOTE: The piston ring gaps and oil supply
ring elements must be distributed evenly
around the circumference.
Using a suitable piston ring compressor, install
the pistons.
Install clean and dry connecting rod
bearing shells in the connecting rods.
8. CAUTION: Connecting rod bearing cap
bolts must only be used two times.
NOTE: Stamp the bolt heads with a center
punch to indicate usage.
NOTE: The big-end bearing caps
identification marks must point to the front
of the engine.
Install the connecting rod bearing caps.
Tighten the bolts in four stages.
Stage 1: Tighten the bolts finger tight.
Stage 2: 27 Nm.
Stage 3: 60 degrees.
Stage 4: 20 degrees.
After installation lubricate the journals
with engine oil.
9. NOTE: Install a new timing chain rear
housing gasket.
Install the timing chain rear housing.
NOTE: Install a new ladder frame gasket.
10.
Install the ladder frame (14 bolts).
Align the ladder frame flush with the
cylinder block.
Tighten the bolts in the sequence shown.
http://vnx.su
engine oil.