Ford Transit 2002 Owner's Manual page 117

8. CAUTION: Support the halfshaft. The
inner joint must not be bent more than 18
degrees. The outer joint must not be bent
more than 45 degrees.
Using a suitable
halfshaft from the wheel hub.
CAUTIONS:
9.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees.
The outer joint must not be bent more than
45 degrees.
Do not damage the halfshaft seal.
Plug the transaxle to prevent oil loss
and dirt ingress.
Using the special tool, remove the halfshaft.
Discard the snap ring.
Allow the oil to drain into a suitable
container.
Installation
CAUTIONS:
1.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft seal.
Make sure that the snap ring is correctly
seated.
NOTE: Install a new snap ring.
Attach the left-hand halfshaft to the transaxle.
2. Using the special tool, install the halfshaft.
WARNING: Install a new lower arm ball
3.
joint retaining nut. Failure to follow this
instruction may result in personal injury.
CAUTION: Protect the heat shield using
http://vnx.su
three leg puller, detach the