Chrysler 2005 Crossfire SRT6 Service Manual page 1153

ZH
HEADLAMP DIAGNOSIS
CONDITION
HEADLAMPS ARE DIM
WITH ENGINE IDLING OR
IGNITION TURNED OFF
HEADLAMP BULBS BURN
OUT FREQUENTLY
HEADLAMPS ARE DIM
WITH ENGINE RUNNING
ABOVE IDLE
HEADLAMPS FLASH
RANDOMLY
HEADLAMPS DO NOT
ILLUMINATE
SPECIFICATIONS - EXTERIOR LAMPS
CAUTION: Do not use bulbs other than those listed in the Bulb Application Table. Damage to lamp can
result. Do not touch halogen bulbs with fingers or other oily surfaces. Bulb life will be reduced.
BULB APPLICATION TABLE
Backup Lamp
Front Fog Lamp
Front Marker Lamp
Front Position Lamp
Front Turn Signal
Headlamp-High Beam
Headlamp-Low Beam
Rear Marker Lamp
Turn Signal Lamp
Tail/Stop Lamp
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION 8L - 87
POSSIBLE CAUSES
1. Loose or corroded battery cables.
2. Loose or worn generator drive belt.
3. Charging system output too low.
4. Battery has insufficient charge.
5. Battery is sulfated or shorted.
6. Both headlamp bulbs are defective.
1. Charging system output too high.
2. Loose or corroded terminals or
splices in circuit.
1. Charging system output too low.
2. Both headlamp bulbs defective.
1. Faulty headlamp switch.
2. Loose or corroded terminals or
splices in circuit.
1. No voltage to headlamps.
2. No ground at headlamps.
3. Faulty headlamp switch.
LAMP
CORRECTION
1. Clean and secure battery
cable clamps and posts.
2. Adjust or replace generator
drive belt.
3. Test and repair charging
system.
4. Test battery state-of-charge.
5. Load test battery.
6. Replace both headlamp bulbs.
1. Test and repair charging
system.
2. Inspect and repair all
connectors and splices.
1. Test and repair charging
system.
2. Replace both headlamp bulbs.
1. Replace headlamp switch.
2. Inspect and repair all
connectors and splices.
1. Check fuse. If good, repair
open headlamp circuit.
2. Repair circuit ground.
3. Replace headlamp switch.
BULB
21W
HB4 55W
W5W
W5W
Y21W
12V55W H7U
12V55W H7U
W5W
Y21W
21/5W