Chrysler 2005 Crossfire SRT6 Service Manual page 1423

ZH
RIGHT SIDE IMPACT SENSOR SIGNAL CIRCUIT (CONTINUED)
2.
MEASURE THE RIGHT SIDE IMPACT SENSOR SIGNAL CIRCUIT RESISTANCE
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Right Side Impact Sensor Signal circuit
from the Right Side Impact Sensor harness connector to the ORC har-
ness connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 3
No >> Repair the Right Side Impact Sensor Signal circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
3.
MEASURE THE RIGHT SIDE IMPACT SENSOR SIGNAL CIRCUIT RESISTANCE
With the ignition off.
Measure the resistance between ground and the Right Side Impact
Sensor Signal circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Right Side Impact Sensor Signal circuit for a
short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 4
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 67