Chrysler 2005 Crossfire SRT6 Service Manual page 724

8E - 22 ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS
*NO RESPONSE FROM INSTRUMENT CLUSTER (CONTINUED)
7.
DISCONNECT MODULES
Note: The Instrument Cluster, Universal Garage Door Opener/Tire
Pressure Monitor, A/C Heater Control Module and Power Top Con-
trol Module (if equipped) all use the SCI Transmit circuit at DLC
cavity 15 to communicate with the DRB III . If one of these mod-
ules keeps the SCI Transmit circuit artificially high or low, the
DRB III will not be able to communicate with any of the four
modules.
Note: Perform the following steps for each of the modules until
communication is restored with the other modules or until each
of the modules has been eliminated as the cause of the fault.
Turn the ignition off.
Disconnect each of the modules noted above, one at a time.
Turn the ignition on.
Using the DRB III , attempt to communicate with any of the three modules still connected.
Is the DRB III able to communicate with the module selected?
Yes >> Replace the module that was disconnected when communication was restored to the other two mod-
ules.
Perform BODY VERIFICATION TEST.
No >> Go to 8
8.
SCI TRANSMIT CIRCUIT SHORTED TO VOLTAGE
Turn the ignition off.
Disconnect the harness connectors for the IC, UGDO/TPM, A/C
Heater Control Module, and Power Top Control Module (if equipped).
Turn the ignition on.
Measure the voltage of the SCI Transmit circuit at the IC C1 harness
connector.
Is the voltage below 0.5 volt?
Yes >> Go to 9
No >> Repair the SCI Transmit circuit for a short to voltage.
Perform BODY VERIFICATION TEST.
ZH