Chrysler 2005 Crossfire SRT6 Service Manual page 964

8J - 10 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
FUEL LEVEL SENSOR CIRCUIT (CONTINUED)
2.
MEASURE FUEL LEVEL SENSOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Fuel Level
Sensor harness connector.
Measure the resistance of the Fuel Level Sensor circuit from cavity D4
to cavity D5 at the Instrument Cluster C2 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Instrument Cluster. (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - DIAGNOSIS AND TEST-
ING).
Perform BODY VERIFICATION TEST.
No >> Repair the appropriate Fuel Level Sensor circuit for an
open.
Perform BODY VERIFICATION TEST.
ZH