Chrysler 2005 Crossfire SRT6 Service Manual page 1239

ZH
BODY CONTROL MODULE INTERNAL FAILURE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: If the Body Control Module (BCM) detects an internal malfunction, the DTC is set.
OPEN FUSED B(+) CIRCUIT
BODY CONTROL MODULE
For a complete Body Control Module (BCM) Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER LOCKS - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
MEASURE THE VOLTAGE OF THE BCM POWER CIRCUIT
Turn the ignition off.
Disconnect the BCM harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the voltage of the Fused B(+) circuit (cavity 75) at the BCM
C4 harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
2.
MEASURE THE VOLTAGE OF THE BCM POWER CIRCUIT
Measure the voltage of the Fused B(+) circuit (cavity 44) at the BCM
C4 harness connector.
Is the voltage above 10 volts?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
POWER LOCKS - ELECTRICAL DIAGNOSTICS 8N - 9
POSSIBLE CAUSES