Chrysler 2005 Crossfire SRT6 Service Manual page 1458

8O - 102 RESTRAINTS - SERVICE INFORMATION
Note: If the driver airbag has been deployed, the clockspring must be replaced. (Refer to 8 - ELECTRICAL/
RESTRAINTS/CLOCKSPRING - REMOVAL).
INSTALLATION
1. Verify the negative battery cable (2) is discon-
nected before proceeding. Wait two minutes for
the system capacitor to discharge before fur-
ther service.
2. Position the driver airbag close enough to the steering wheel to connect the squib and horn harness connections.
(ART)
CAUTION: Use caution when connecting the clockspring connector to the driver airbag inflator connector
receptacle. Improper assembly of these wires or connector insulators can result in damage to the airbag
circuits or connector insulators.
3. Carefully position the driver airbag in the steering wheel.
Note: Be certain that the clockspring wires and horn switch harness in the steering wheel hub area are not
pinched between the driver airbag and the steering wheel.
4. From the underside of the steering wheel, install
and tighten the two screws (1) that secure the
driver airbag to the steering wheel. Tighten to 8
N·m (71 in. lbs.).
5. Do not reconnect the negative battery cable at this
time. Perform the Supplemental Restraint System
verification test procedure after servicing any Sup-
plemental Restraint System component. (Refer to 8
- ELECTRICAL/RESTRAINTS
PROCEDURE).
- STANDARD
ZH