Chrysler 2005 Crossfire SRT6 Service Manual page 1524

8Q - 18 VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS
DOOR LOCK SWITCH SENSE CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: The Sentry Key Remote Entry Module (SKREEM) reports a short to power, ground, or an open
circuit failure on the Door Lock Switch Sense circuit.
DOOR LOCK SWITCH SENSE CIRCUIT SHORTED TO VOLTAGE
DOOR LOCK SWITCH SENSE CIRCUIT SHORTED TO GROUND
DOOR LOCK SWITCH SENSE CIRCUIT OPEN
SENTRY KEY REMOTE ENTRY MODULE
For a complete Vehicle Theft Security System Circuit Diagram, (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
MEASURE THE RESISTANCE OF THE DOOR LOCK SWITCH SENSE CIRCUIT
Turn the ignition off.
Disconnect the BCM harness connector.
Disconnect the SKREEM harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Door Lock Switch Sense circuit from the
BCM harness connector to the SKREEM harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Door Lock Switch Sense circuit for an open.
Perform VTSS VERIFICATION TEST.
POSSIBLE CAUSES
ZH