Chrysler 2005 Crossfire SRT6 Service Manual page 1217

ZH LAMPS/LIGHTING - INTERIOR - SERVICE INFORMATION 8L - 151
DIMMER SWITCH
DESCRIPTION
The dimmer switch (3) is an integrated part of the
Instrument Cluster and is located at the left side of the
speedometer. It controls the brightness of the adjust-
able interior illumination when rotated to the left or
right. The dimmer switch cannot be repaired. If it is
found faulty or damaged, the entire Instrument Cluster
must be replaced. For complete Instrument Cluster
removal procedures, refer to Instrument Cluster
removal in the Instrument Cluster section.
DOOR AJAR SWITCH
DESCRIPTION
There are three door ajar switches, one at each door and one in the liftgate latch. The door switches are located in
the B-pillar directly below the latch striker plate, and the liftgate switch is integral to the liftgate latch assembly. A
door or body harness connector with a service loop connects each switch to the vehicle electrical system. The door
ajar switches cannot be adjusted or repaired, and if faulty or damaged, the switch itself or the liftgate latch must be
replaced as an assembly. For complete door ajar switch removal procedures, see the appropriate removal proce-
dure in this section.
OPERATION
The door ajar switches are actuated by either door, or the liftgate being opened. When either door or the liftgate is
closed and properly latched, its ajar switch is open. When either door or the liftgate is partially latched, its ajar
switch is closed. The ajar switches are connected via a harness connector to a body ground and the Central Lock-
ing Pump/Security System Module.